Development application

PE foam isolation shell for equipment

This 20 kg/m³ PE foam shell was developed to isolate equipment within an exterior hard case. FFG revised the shell design to work with the case closing mechanism. Male and female shells are available in the design; only the male shell is illustrated here. A prototype was CNC machined, with production in EPE (expanded polyethylene).

Discuss a similar application

Documented specification

Material
PE foam, 20 kg/m³
Treatment
Flame-retardant treatment; rating and test standard not supplied
Shell configuration
Male and female shells; male shell only illustrated
FFG contribution
Design revision around the exterior hard case closing mechanism
Prototype
CNC machined
Production material
EPE (expanded polyethylene)

Compare foam materials and specifications ↗

Adapted application illustration of the male PE foam shell, shown from an interior oblique angle. The female shell is not pictured.
Adapted application illustrationMale shell only. This confidentiality-adapted geometry does not show the exact customer design or establish tested fit or protection.

Shells around the equipment and case

The paired shell concept can be used inside a drone protection and launch box. A similar approach can be considered for sliding shells around sensitive industrial equipment. These are application directions; the required protection and operating conditions must be defined for each assembly.

Design for the closing mechanism

FFG revised the foam-shell design according to the way the exterior hard case closes. The male and female parts need to be considered together with the case movement and equipment interfaces. The illustration shows only the male part and is not a fit drawing.

Prototype and production

The prototype was made by CNC machining. Production uses EPE, expanded polyethylene. This distinguishes the machined development part from the production material without implying a particular molding process or tooling method.

Define a similar shell

Share the equipment envelope, hard case drawings, closure travel, shell mating surfaces and required handling conditions. Specify any flame-retardance criteria and the tests needed for your application. No protection result or fire classification is stated for this example.

Build a useful enquiry

Share the part or assembly drawing, overall dimensions, material or grade if known, interfaces, quantities and timing. Include the requirements you need to validate.

Discuss a similar application